[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <6fb3fadc03e6d74831e77591b19e7b36@smtp.hushmail.com>
Date: Sun, 28 May 2017 21:09:45 +0200
From: magnum <john.magnum@...hmail.com>
To: john-users@...ts.openwall.com
Subject: Re: CL_OUT_OF_RESOURCES error with --format=dmg-opencl
On 2017-05-26 16:15, B B wrote:
> I tried to —restore a session and got the line 1820 error with a new installation. I specified the LWS and GWS with the restored session but for some reason it ran at 500p/s even so. I then restarted that session (as new) and while it did not seem, or output the results, to build the kernel (where is that?) it was very very fast to get going and I also regained previous speeds of +700p/s with my Nvidia card.
Note that the speed shown in status output is the average from the very
start of job (ie. complete run-time since original start of job - not
just this resume session) so if you run at some poor speed for several
hours and then resume with much better speed, it won't show in the
status until run long enough to change the average. I think that's what
confusing you.
magnum
Powered by blists - more mailing lists
Confused about mailing lists and their use?
Read about mailing lists on Wikipedia
and check out these
guidelines on proper formatting of your messages.
